It is usually faster to just redraw the geometry.Īhhh, another thought for you, if the perimeter of the part is not cut out you would have no idea of where the other geometry actually belongs in space, especially since the zero could be in the middle, a corner, the center of the bottom edge or anywhere else that was convenient when the program was written. To get started you will need to download the Vectric CAM Processor file from Easel. Have messed around with a few gcode to dxf file converters.I said it just right, messed around. I know, stuff like this sounds like it should be simple, but it is not. It can get worse, think about trying to convert a gcode file that uses a ball nose endmill or a tapered ball nose. Then, as I mentioned above, there is no way of determining the actually geometry of the pocket unless the tool diameter is known. All the interior moves usually wind up showing as geometry. A gcode file does not contain tool information unless it is supplied in a comment header.Īn issue arises when gcode cuts pockets.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |